機械工程師必備辭彙

   時間:2014-03-07 11:39:39
機械工程師必備辭彙簡介
1 backplane 背板 2 Band gap voltage reference 帶隙電壓參考 3 benchtop supply 工作台電源 4 Block Diagr……
機械工程師必備辭彙正文

1 backplane 背板
2 Band gap voltage reference 帶隙電壓參考
3 benchtop supply 工作台電源
4 Block Diagram 方塊圖
5 Bode Plot 波特圖
6 Bootstrap 自舉
7 Bottom FET Bottom FET
8 bucket capcitor 桶形電容
9 chassis 機架
10 Combi-sense Combi-sense
11 constant current source 恆流源
12 Core Sataration 鐵芯飽和
13 crossover frequency 交叉頻率
14 current ripple 紋波電流
15 Cycle by Cycle 逐周期
16 cycle skipping 周期跳步
17 Dead Time 死區時間
18 DIE Temperature 核心溫度
19 Disable 非使能,無效,禁用,關斷
20 dominant pole 主極點
21 Enable 使能,有效,啟用
22 ESD Rating ESD額定值
23 Evaluation Board 評估板
24 Exceeding the specifications below may result in permanent damage to the device, or device malfunction. Operation outside of the parameters specified in the Electrical Characteristics section is not implied. 超過下面的規格使用可能引起永久的設備損害或設備故障.建議不要工作在電特性表規定的參數範圍以外.
25 Failling edge 下降沿
26 figure of merit 品質因數
27 float charge voltage 浮充電壓
28 flyback power stage 反馳式功率級
29 forward voltage drop 前向壓降
30 free-running 自由運行
31 Freewheel diode 續流二極體
32 Full load 滿負載
33 gate drive 柵極驅動
34 gate drive stage 柵極驅動級
35 gerber plot Gerber 圖
36 ground plane 接地層
37 Henry 電感單位:亨利
38 Human Body Model 人體模式
39 Hysteresis 滯回
40 inrush current 湧入電流
41 Inverting 反相
42 jittery 抖動
43 Junction 結點
44 Kelvin connection 開爾文連接
45 Lead Frame 引腳框架
46 Lead Free 無鉛
47 level-shift 電平移動
48 Line regulation 電源調整率
49 load regulation 負載調整率
50 Lot Number 批號
51 Low Dropout 低壓差
52 Miller 密勒
53 node 節點
54 Non-Inverting 非反相
55 novel 新穎的
56 off state 關斷狀態
57 Operating supply voltage 電源工作電壓
58 out drive stage 輸出驅動級
59 Out of Phase 異相
60 Part Number 產品型號
61 pass transistor pass transistor
62 P-channel MOSFET P溝道MOSFET
63 Phase margin 相位裕度
64 Phase Node 開關節點
65 portable electronics 攜帶型電子設備
66 power down 掉電
67 Power Good 電源正常
68 Power Groud 功率地
69 Power Save Mode 節電模式
70 Power up 上電
71 pull down 下拉
72 pull up 上拉
73 Pulse by Pulse 逐脈衝(Pulse by Pulse)
74 push pull converter 推挽轉換器
75 ramp down 斜降
76 ramp up 斜升
77 redundant diode 冗餘二極體
78 resistive divider 電阻分壓器
79 ringing 振 鈴
80 ripple current 紋波電流
81 rising edge 上升沿
82 sense resistor 檢

 

測電阻
83 Sequenced Power Supplys 序列電源
84 shoot-through 直通,同時導通
85 stray inductances. 雜散電感
86 sub-circuit 子電路
87 substrate 基板
88 Telecom 電信
89 Thermal Information 熱性能信息
90 thermal slug 散熱片
91 Threshold 閾值
92 timing resistor 振蕩電阻
93 Top FET Top FET
94 Trace 線路,走線,引線
95 Transfer function 傳遞函數
96 Trip Point 跳變點
97 turns ratio 匝數比,=Np / Ns.(初級匝數/次級匝數)
98 Under Voltage Lock Out (UVLO) 欠壓鎖定
99 Voltage Reference 電壓參考
100 voltage-second product 伏秒積
101 zero-pole frequency compensation 零極點頻率補償
102 beat frequency 拍頻
103 one shots 單擊電路
104 scaling 縮放
105 ESR 等效串聯電阻
106 Ground 地電位
107 trimmed bandgap 平衡帶隙
108 dropout voltage 壓差
109 large bulk capacitance 大容量電容
110 circuit breaker 斷路器
111 charge pump 電荷泵
112 overshoot 過沖

--------------------------------------------------------------------------------

1) 元件設備
三繞組變壓器:three-column transformer ThrClnTrans
雙繞組變壓器:double-column transformer DblClmnTrans
電容器:Capacitor
並聯電容器:shunt capacitor
電抗器:Reactor
母線:Busbar
輸電線:TransmissionLine
發電廠:power plant
斷路器:Breaker
刀閘(隔離開關):Isolator
分接頭:tap
電動機:motor
(2) 狀態參數
有功:active power
無功:reactive power
電流:current
容量:capacity
電壓:voltage
檔位:tap position
有功損耗:reactive loss
無功損耗:active loss
功率因數:power-factor
功率:power
功角:power-angle
電壓等級:voltage grade
空載損耗:no-load loss
鐵損:iron loss
銅損:copper loss
空載電流:no-load current

阻抗:impedance
正序阻抗:positive sequence impedance
負序阻抗:negative sequence impedance
零序阻抗:zero sequence impedance
電阻:resistor
電抗:reactance
電導:conductance
電納:susceptance
無功負載:reactive load 或者QLoad
有功負載: active load PLoad
遙測:YC(telemetering)
遙信:YX
勵磁電流(轉子電流):magnetizing current
定子:stator
功角:power-angle
上限:upper limit
下限:lower limit
並列的:apposable
高壓: high voltage
低壓:low voltage
中壓:middle voltage

電力系統 power system
發電機 generator
勵磁 excitation
勵磁器 excitor
電壓 voltage
電流 current
母線 bus
變壓器 transformer
升壓變壓器 step-up transformer
高壓側 high side
輸電系統 power transmission system
輸電線 transmission line
固定串聯電容補償fixed series capacitor compensation
穩定 stability
電壓穩定 voltage stability
功角穩

 

定 angle stability
暫態穩定 transient stability
電廠 power plant
能量輸送 power transfer
交流 AC
裝機容量 installed capacity
電網 power system
落點 drop point
開關站 switch station
雙回同桿並架 double-circuit lines on the same tower
變電站 transformer substation
補償度 degree of compensation
高抗 high voltage shunt reactor
無功補償 reactive power compensation
故障 fault
調節 regulation
裕度 magin
三相故障 three phase fault
故障切除時間 fault clearing time
極限切除時間 critical clearing time
切機 generator triping
高頂值 high limited value
強行勵磁 reinforced excitation
線路補償器 LDC(line drop compensation)
機端 generator terminal
靜態 static (state)
動態 dynamic (state)
單機無窮大系統 one machine - infinity bus system
機端電壓控制 AVR
電抗 reactance
電阻 resistance
功角 power angle
有功(功率) active power
無功(功率) reactive power
功率因數 power factor
無功電流 reactive current
下降特性 droop characteristics
斜率 slope
額定 rating
變比 ratio
參考值 reference value
電壓互感器 PT
分接頭 tap
下降率 droop rate
模擬分析 simulation analysis
傳遞函數 transfer function
框圖 block diagram
受端 receive-side
裕度 margin
同步 synchronization
失去同步 loss of synchronization
阻尼 damping
搖擺 swing
保護斷路器 circuit breaker

電阻:resistance
電抗:reactance
阻抗:impedance

電導:conductance
電納:susceptance
導納:admittance

電感:inductance
電容: capacitance

--------------------------------------------------------------------------------
printed circuit 印製電路
printed wiring 印製線路
printed board 印製板
printed circuit board 印製板電路
printed wiring board 印製線路板
printed component 印製元件
printed contact 印製接點
printed board assembly 印製板裝配
board 板
rigid printed board 剛性印製板
flexible printed circuit 撓性印製電路

 

[機械工程師必備辭彙],你可能也喜歡

  • 機械製圖教學
  • 電腦輔助機械製圖
  • 機械製圖
  • 機械製圖符號
  • 機械製圖軟體
  • 工程製圖軟體
  • 機械工程製圖大意
  • 工程圖學與機械製圖
  • 工程製圖符號
  • tqc工程製圖
  • 機械設計工程師
  • 機械工程師手冊
  • cad繪圖工程師
  • 機械設計工程師認證
  • 初級機械設計工程師
  • cad cam工程師必備條件
  • 銀牌場必備知識
  • 生活必備知識
  • 電腦必備知識
  • 水電必備知識
Bookmark the permalink ,來源:
One thought on “機械工程師必備辭彙